ABB · Other Industrial Electronics
ABB M600 repair
Component-level repair for the ABB M600 (control card, machine hv2001), onsite or sent in from anywhere in India. The diagnosis and repair cost are confirmed before any work starts.
Cost confirmed before any work starts · Warranty of 30 days to 6 months
At a glance
The ABB M600
- Manufacturer
- ABB
- Model / part number
- M600
- Description
- Control card, machine HV2001
- Category
- Other Industrial Electronics
- Service
- Diagnosis and component-level repair, onsite or ship-in
- Warranty
- 30 days to 6 months, confirmed before work starts
ABB equipment in Indian plants ranges from ACS and DCS series drives and Unitrol excitation systems to AC500 PLCs, 800xA and older DCS hardware, protection relays and robot controllers.
Common faults
What usually fails on a unit like the M600
Weld controls, printing and imaging units, security systems and other machine electronics share the same weak points as any industrial electronics: power sections, interface boards, displays and connectors.
Power section faults
Failed supplies, inverters and power boards.
Control board faults
Processor, memory and interface faults.
Display and control panel faults
Dead displays and keypads.
Connector and cable damage
Heat, vibration and moisture damage.
Sensor and input faults
Inputs damaged by wiring faults or surges.
Board-level repair
This is repaired at component level: the board is traced, the failed parts are replaced, and the board is tested with its inputs and outputs before it is returned.
First checks
What to check before calling an engineer
Isolate and lock out the supply, and wait for stored energy to discharge, before opening anything.
Safe for plant staff
- Note the fault and any error message.
- Check supplies and cables.
- Photograph connections before removal.
Leave to a specialist
- Board-level repair and testing.
- Work on high-voltage sections.
Getting it fixed
How to get the M600 repaired
What to send with it
- The unit or board.
- The machine it comes from.
- The fault and error messages.
Onsite or ship-in
Technicians work onsite from our Hyderabad base and travel to plants across India; anything that can be removed can also be sent to MachineryFix from anywhere in the country.
Warranty. Repairs carry a warranty of 30 days to 6 months, depending on the item and the repair; the exact term is confirmed before work starts.
FAQ
M600 repair questions
Does the ABB M600 have to be sent in, or can an engineer come to the plant?+
Either. An engineer can diagnose it in place and repair it there or take it away, or the unit can be sent to MachineryFix from anywhere in India. The diagnosis and repair cost are confirmed before any work starts.
Is MachineryFix connected to ABB?+
No. ABB and the model name are used only to identify the equipment. MachineryFix is an independent repair service and is not affiliated with or endorsed by ABB.
Other manufacturers
Other Industrial Electronics from other makers
ABB and M600 are named only to identify the equipment. MachineryFix is not affiliated with or endorsed by ABB.
M600 down?
Send the fault and what the machine was doing. We'll match an engineer who works on it.