MachineryFix

ABB · Soft Starters

ABB STARTER PST142-600-70 repair

Get the ABB STARTER PST142-600-70 repaired rather than replaced. It is matched to an engineer who works on ABB soft starters, and the cost is confirmed before work starts.

Cost confirmed before any work starts · Warranty of 30 days to 6 months

At a glance

The ABB STARTER PST142-600-70

Manufacturer
ABB
Model / part number
STARTER PST142-600-70
Also searched as
STARTERPST14260070 · STARTER PST142 600 70
Description
Of SOFT control card
Category
Soft Starters
Service
Diagnosis and component-level repair, onsite or ship-in
Warranty
30 days to 6 months, confirmed before work starts

ABB equipment in Indian plants ranges from ACS and DCS series drives and Unitrol excitation systems to AC500 PLCs, 800xA and older DCS hardware, protection relays and robot controllers.

Common faults

What usually fails on a unit like the STARTER PST142-600-70

Soft starters are simpler than drives, but they work hard: every start pushes high current through the thyristors. Most faults are in the power section, the bypass contactor or the control card.

Board-level repair

This is repaired at component level: the board is traced, the failed parts are replaced, and the board is tested with its inputs and outputs before it is returned.

First checks

What to check before calling an engineer

Isolate and lock out the supply, and wait for stored energy to discharge, before opening anything.

Getting it fixed

How to get the STARTER PST142-600-70 repaired

What to send with it

  • The soft starter with its control card fitted.
  • The trip message and the motor rating.
  • What it starts (pump, compressor, crusher, fan) and how often.

Onsite or ship-in

Technicians work onsite from our Hyderabad base and travel to plants across India; anything that can be removed can also be sent to MachineryFix from anywhere in the country.

Warranty. Repairs carry a warranty of 30 days to 6 months, depending on the item and the repair; the exact term is confirmed before work starts.

FAQ

STARTER PST142-600-70 repair questions

Why does the ABB STARTER PST142-600-70 trip only after the motor reaches speed?+

That usually points to the bypass contactor or its control, or to heat building up in the starter. Both are checked during the repair.

Does the ABB STARTER PST142-600-70 have to be sent in, or can an engineer come to the plant?+

Either. An engineer can diagnose it in place and repair it there or take it away, or the unit can be sent to MachineryFix from anywhere in India. The diagnosis and repair cost are confirmed before any work starts.

Is MachineryFix connected to ABB?+

No. ABB and the model name are used only to identify the equipment. MachineryFix is an independent repair service and is not affiliated with or endorsed by ABB.

Same manufacturer

Other ABB Soft Starters

Other manufacturers

Soft Starters from other makers

ABB and STARTER PST142-600-70 are named only to identify the equipment. MachineryFix is not affiliated with or endorsed by ABB.

STARTER PST142-600-70 down?

Send the fault and what the machine was doing. We'll match an engineer who works on it.