Itowa · Protection Relays
Itowa Control card, receiver relay repair
Component-level repair for the Itowa Control card, receiver relay (control card, receiver relay), onsite or sent in from anywhere in India. The diagnosis and repair cost are confirmed before any work starts.
Cost confirmed before any work starts · Warranty of 30 days to 6 months
At a glance
The Itowa Control card, receiver relay
- Manufacturer
- Itowa
- Model / part number
- —
- Description
- Control card, receiver relay
- Category
- Protection Relays
- Service
- Diagnosis and component-level repair, onsite or ship-in
- Warranty
- 30 days to 6 months, confirmed before work starts
Itowa equipment in this catalog is listed by model or part number. Send the model from the nameplate and the fault, and it will be matched to an engineer who works on that kind of unit.
Common faults
What usually fails on a unit like the Control card, receiver relay
Protection relays have to trip when needed and stay quiet otherwise, so a repaired relay must be tested against its settings, not just powered up. Power supplies, input boards, displays and output contacts are the usual failure points.
Relay dead or rebooting
Failed internal power supply, often from age or a surge on the auxiliary supply.
Self-supervision or internal fault alarms
Faults in the processor board, memory or analog input stages.
Wrong measurement
Current or voltage inputs reading wrongly because of damaged input transformers or analog circuits.
Output contacts not operating
Burnt or welded output relay contacts, or failed driver circuits.
Display and keypad faults
Unreadable displays and dead keys, which make settings hard to check.
Relays and contacts
Relay outputs are checked for contact resistance and correct operation, since worn contacts give intermittent faults.
First checks
What to check before calling an engineer
Isolate and lock out the supply, and wait for stored energy to discharge, before opening anything.
Safe for plant staff
- Record any self-supervision alarm and the event log.
- Check the auxiliary supply voltage.
- Keep a copy of the settings file.
Leave to a specialist
- Secondary injection testing after repair.
- Changing or uploading relay settings.
- Any work on CT and VT circuits: open CT secondaries are dangerous.
Getting it fixed
How to get the Control card, receiver relay repaired
What to send with it
- The relay, with its settings file if possible.
- The alarm or event log.
- The CT and VT ratings it is set for.
Onsite or ship-in
Technicians work onsite from our Hyderabad base and travel to plants across India; anything that can be removed can also be sent to MachineryFix from anywhere in the country.
Warranty. Repairs carry a warranty of 30 days to 6 months, depending on the item and the repair; the exact term is confirmed before work starts.
FAQ
Control card, receiver relay repair questions
How is the Itowa Control card, receiver relay tested after repair?+
Beyond powering up, the relay is checked with secondary injection so its measuring inputs, protection functions and output contacts are confirmed to work.
Does the Itowa Control card, receiver relay have to be sent in, or can an engineer come to the plant?+
Either. An engineer can diagnose it in place and repair it there or take it away, or the unit can be sent to MachineryFix from anywhere in India. The diagnosis and repair cost are confirmed before any work starts.
Is MachineryFix connected to Itowa?+
No. Itowa and the model name are used only to identify the equipment. MachineryFix is an independent repair service and is not affiliated with or endorsed by Itowa.
Other manufacturers
Protection Relays from other makers
Itowa and Control card, receiver relay are named only to identify the equipment. MachineryFix is not affiliated with or endorsed by Itowa.
Control card, receiver relay down?
Send the fault and what the machine was doing. We'll match an engineer who works on it.