Yokogawa · Temperature & Process Controllers
Yokogawa SR10006 repair
Get the Yokogawa SR10006 repaired rather than replaced. It is matched to an engineer who works on Yokogawa controllers, and the cost is confirmed before work starts.
Cost confirmed before any work starts · Warranty of 30 days to 6 months
At a glance
The Yokogawa SR10006
- Manufacturer
- Yokogawa
- Model / part number
- SR10006
- Description
- CHART recorder
- Category
- Temperature & Process Controllers
- Service
- Diagnosis and component-level repair, onsite or ship-in
- Warranty
- 30 days to 6 months, confirmed before work starts
Yokogawa makes CENTUM and STARDOM control systems, field instruments such as EJA and EJX transmitters, analysers, recorders and digital indicating controllers used across process industries.
Common faults
What usually fails on a unit like the SR10006
Temperature, PID and burner controllers are small but critical: when one fails, a furnace, oven or process loop stops. Most faults are in the power section, input circuits or output relays, and the controller can be repaired and checked against a calibrated source.
Wrong or unstable reading
Damaged thermocouple or RTD input circuits, often from a sensor short or a surge on the sensor wiring.
Output not switching
Burnt output relays, failed SSR drivers or damaged analog output stages.
Dead display
Failed internal power supply or display driver.
Lost configuration
Memory faults that reset the input type, range or alarms.
Burner sequence faults
Flame detection, valve proving and ignition faults in burner controllers.
First checks
What to check before calling an engineer
Isolate and lock out the supply, and wait for stored energy to discharge, before opening anything.
Safe for plant staff
- Check the sensor and its wiring before blaming the controller.
- Note the input type and range configured.
- Record the alarm or error shown.
Leave to a specialist
- Calibrating inputs and outputs.
- Any work on burner management and flame safety systems.
- Changing control configuration on a running process.
Getting it fixed
How to get the SR10006 repaired
What to send with it
- The controller.
- Its input type, range and output configuration if known.
- The sensor type it reads.
Onsite or ship-in
Technicians work onsite from our Hyderabad base and travel to plants across India; anything that can be removed can also be sent to MachineryFix from anywhere in the country.
Warranty. Repairs carry a warranty of 30 days to 6 months, depending on the item and the repair; the exact term is confirmed before work starts.
FAQ
SR10006 repair questions
Is the Yokogawa SR10006 calibrated after repair?+
The input is checked against a calibrated source over its range, and outputs are confirmed to switch, so the controller reads and acts correctly when refitted.
Does the Yokogawa SR10006 have to be sent in, or can an engineer come to the plant?+
Either. An engineer can diagnose it in place and repair it there or take it away, or the unit can be sent to MachineryFix from anywhere in India. The diagnosis and repair cost are confirmed before any work starts.
Is MachineryFix connected to Yokogawa?+
No. Yokogawa and the model name are used only to identify the equipment. MachineryFix is an independent repair service and is not affiliated with or endorsed by Yokogawa.
Same manufacturer
Other Yokogawa Temperature & Process Controllers
Other manufacturers
Temperature & Process Controllers from other makers
Yokogawa and SR10006 are named only to identify the equipment. MachineryFix is not affiliated with or endorsed by Yokogawa.
SR10006 down?
Send the fault and what the machine was doing. We'll match an engineer who works on it.