MachineryFix

322 models · 129 manufacturers

Temperature & Process Controllers repair

Temperature, PID, pressure and burner controllers, programmers and chart recorders. Temperature, PID and burner controllers are small but critical: when one fails, a furnace, oven or process loop stops. Most faults are in the power section, input circuits or output relays, and the controller can be repaired and checked against a calibrated source.

Manufacturers

Temperature & Process Controllers by manufacturer

Models

Temperature & Process Controllers in the catalog

A selection. Pick a manufacturer above for the full list, or search by part number at the top of the catalog.

Common faults

What usually fails on Temperature & Process Controllers

First checks

What to check before calling an engineer

Isolate and lock out the supply, and wait for stored energy to discharge, before opening anything.

Warranty. Repairs carry a warranty of 30 days to 6 months, depending on the item and the repair; the exact term is confirmed before work starts.

FAQ

Temperature & Process Controllers repair questions

Is the controller calibrated after repair?+

The input is checked against a calibrated source over its range, and outputs are confirmed to switch, so the controller reads and acts correctly when refitted.

More manufacturers

Temperature & Process Controllers from other manufacturers

Don't see your model?

Engineers on MachineryFix work on far more models than are listed here. Send the make, the model or part number from the nameplate, and the fault, and we'll match an engineer who works on it.

Enter the make and model to continue.

Temperature & Process Controllers down?

Send the make, model and fault. We'll match an engineer who works on it.